Antler Ceiling Fan Light - Guess what? The title of the article is simply out-and-out misleading. The sole actual "con" as it pertains to your ceiling fan is what it will take to get one properly installed. Ceiling fans may be difficult to install for the inexperienced do it yourselfer. Sometimes, where the ceiling fan is to be set up, you'll need to run an electric line to the area. Hiring a qualified, bonded and licensed electrician will most likely save you a lot of grief in the future unless you are skillful at achieving this kind of thing.
There's also the minor "disadvantage" that entails the issue of periodic care. Properly installed, a ceiling fan will provide years and years of nice cooling and cost-savings in your heat bill (assuming you've got a fan that enables you to reverse the blade direction). Allowed, you should wipe down the blades in a while but then, everyone has household cleaning chores to take good care of of from time to time.
On occasion, ceiling fans get out of balance and need small adjustments. The most often encountered culprits are loose screws that attach the blades to the motor casing, blades which are not at the same angle (pitch) as the rest of the blades as well as a blade or blades that weigh slightly more in relation to the others. Without going into great detail, ensure that all of the screws are tight. If they truly aren't tightening the ones that have come loose and run the fan. Your issue was solved, in the event the wobbling has stopped.
If not, use a yardstick or another straight bit of wood and place it (with the fan quit) vertically in the outer edge of among the blades. Rotate the blades by hand to make sure that the stick touches. If one or more don't, only (and gradually) bend the blade(s) so that their pitch matches the others and repeat the procedure until you are satisfied that each blade has the same pitch. Turn the fan on again and see if you've solved the difficulty.